研究目的
Investigating the feasibility of bridging the unsteady and steady mechanisms of underwater propulsion in nature and engineering by colocating their flapping and steady lifting surfaces in an outwardly conventional propulsor.
研究成果
The study demonstrates the feasibility of integrating unsteady and steady mechanisms of underwater propulsion in a single propulsor. The slosh mode allows for transient-free thrust reversal and fine control of thrust amplitude through fin twisting, suggesting potential applications in low-speed maneuvering and control.
研究不足
The tow speeds are low and close to the minimum induced velocity required for thrust onset by the flapping mechanism, limiting the range of conditions under which the propulsor can be tested. The mechanical complexity of the propulsor may also limit its practical applications.
1:Experimental Design and Method Selection:
The propulsor was designed to operate in both slosh and prop modes, allowing for the comparison of unsteady and steady mechanisms of lift generation.
2:Sample Selection and Data Sources:
A novel,
3:7-m diameter propulsor with twistable fins was built and tested in a tow tank. List of Experimental Equipment and Materials:
The propulsor included fins twistable along their span, an ATI Delta IP68 US-50–150 load cell, and a Net F/T signal conditioner for force measurements.
4:Experimental Procedures and Operational Workflow:
The propulsor was tested in both slosh and prop modes at low tow speeds (0 to
5:09 m/s) to measure thrust, with variations in pitch and twist amplitudes. Data Analysis Methods:
Time-averaged measurements and modeling (steady and quasi-steady) were used to compare thrust properties in the two modes.
独家科研数据包,助您复现前沿成果,加速创新突破
获取完整内容