- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Sandwich magnetically imprinted immunosensor for electrochemiluminescence ultrasensing diethylstilbestrol based on enhanced luminescence of Ru@SiO2 by CdTe@ZnS quantum dots
摘要： A molecularly imprinted magnetic sensor with electroluminescent tags (MIP-ECL sensor) was developed for ultrasensing diethylstilbestrol (DES). A strategy is exploited to enhance ECL emission of the [Ru(bpy)3]2 +-tripropyl amine (TPrA) system by CdTe@ZnS quantum-dots (QDs) through energy transfer. Magnetically molecularly imprinted nanoparticles (MMIPs NPs) based on Fe3O4@SiO2 carriers are artificial, easily reproducible, and could replace easily inactivated first antibodies for capturing more DES molecules. Functionalized bio-conjugates of single antibody-CdTe@ZnS (Ab-CdTe@ZnS) are for the first time loaded on signal labels of Ru(bpy)3 2 +-doped silica nanocomposites (Ru@SiO2) for signal amplification. The final bio-conjugated signal probes are denoted as Ab-DES/CdTe@ZnS-Ru@SiO2. MMIPs beads that have captured antigens are bio-conjugated with antibody-labeled luminescent probes by specific immunoreactive reaction, and then the luminescent immunocomplex generates ECL signal on the magnetic electrode. The logarithm of ECL intensities depend linearly on the logarithm of DES concentrations in the range from 4.8×10? 4 to 36.0 nM with a detection limit of 0.025 pM. This novel assay is much more sensitive than other MIP sensors, and achieves lower cost and more enhanced stability than other immunosensors. The sensor is significantly potential and has been applied to DES detection in actual environment.
关键词： [Ru(bpy)3]2+-doped silica,Probe-mode ECL sensor,Core-shell QDs,Magnetically imprinted nanoparticles,Diethylstilbestrol,Single antibody sandwich-type
更新于2025-09-23 15:19:57
-
Electrochemiluminescence solid-state imprinted sensor based on graphene/CdTe@ZnS quantum dots as luminescent probes for low-cost ultrasensing of diethylstilbestrol
摘要： A novel molecularly imprinted electrochemiluminescence (MIP-ECL) sensor was fabricated for diethylstilbestrol (DES), which exploited the strategy of specific identification by molecularly imprinted polymers (MIPs) instead of expensive biomolecules. Core-shell quantum-dots (QDs) of CdTe@ZnS were utilized to enhance ECL emission. The sensor was assembled as a solid-state electrode by immobilizing CdTe@ZnS/reduced-graphene oxide (r-GO) composite on a glassy carbon electrode (GCE) surface, and then being covered with MIPs film with specific cavities. The fabricated sensor (denoted as MIP/CdTe@ZnS/r-GO/GCE) was based on the obstruction of ECL signals by DES molecules enriched on MIP film. The ECL intensity of the QDs-K2S2O8 system was reduced when the DES molecules were selectively rebound onto the MIP film by molecularly imprinted solid phase extraction (MISPE). Accordingly, the logarithm of the quenched ECL intensity versus the logarithm of the DES concentration was in a good linear relationship over a wide range from 1.8×10?3 to 25.0 nmol/L with the limit of detection (LOD) of 0.25 pmol/L (S/N = 3). The sensor also exhibits excellent selectivity with fast response and good accuracy. Lake water and milk samples were assayed by this sensor, and the recoveries ranging from 92.2% to 108.3% were obtained.
关键词： Solid-state electrode,Molecularly imprinted film,Diethylstilbestrol,CdTe@ZnS quantum-dots,Electrochemiluminescence sensor,Solid phase extraction
更新于2025-09-12 10:27:22