- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Evolution of Morphology, Phase Composition and Photoluminescence of Cesium Lead Bromine Nanocrystals with Temperature and Precursors
摘要： Compared with CsPbBr3 nanocrystals (NCs), the study of the structure and physical properties of Cs4PbBr6 and CsPb2Br5 NCs is not sufficient. In this paper, CsPbBr3, CsPb2Br5, and Cs4PbBr6 NCs were prepared by a hot-injection method using oleylamine (OAm) and oleic acid (OA) without adding other ligands. The evolution of phase composition, morphology and photoluminescence (PL) property were investigated. It is found that rhombohedral Cs4PbBr6 was created at low temperature with low Pb/Cs ratios and short reaction time. CsPbBr3 phase was then obtained with increasing Pb/Cs ratios at high temperature through the reaction of Cs4PbBr6 and PbBr2. The evolution of phase composition occurred with time to create CsPbBr3, CsPb2Br5, and Cs4PbBr6 NCs. For a Pb/Cs molar ratio of 3, CsPbBr3 were firstly obtained at 180 °C. However, resulting sample is CsPb2Br5 phase after 120 min. The excesses PbBr2 is a key for such phase change because no similar phenomenon was observed in the case of molar ratio of Pb/Cs of 2. At low temperature (e.g. 140 and 160 °C), rhombohedral Cs4PbBr6 phase was obtained and then reacted with PbBr2 to fabricate cubic CsPbBr3 nanosheets with sizes of several hundred nanometers. With changing phase composition, cubic, rod, rhombohedral morphologies were created. The PL properties of the NCs depended strongly on the phase composition. As a result, CsPbBr3 NCs reveal highly bright PL with narrow and symmetrical PL spectra (PL peak at 520 nm). In contrast, No PL was observed for Cs4PbBr6 and CsPb2Br5 phases. The results provide a possibility to well control the growth for the application of cesium lead halide NCs.
关键词： Cesium lead bromine nanocrystals,Photoluminescence,Morphology,Phase evolution,Hot-injection method
更新于2025-09-23 15:21:01
-
Developing highly crystalline, single-phase and copper-poor Cu2ZnSnSe4 nanoparticles for solar cell application
摘要： In this study, we report the synthesis of Cu(Zn,Sn)Se2 (CZTSe) nanoparticles by hot-injection method for application to the absorber layer in solar cells. The composition of elements in the CZTSe nanoparticles depends mainly on the injection speed of the Se precursor. By controlling the injection speed, we obtained complete single-phase CZTSe nanoparticles with high crystallinity and copper-poor composition. The nanoparticle diameter mainly ranged from ~ 7 nm to 18 nm. The obtained CZTSe nanoparticles were used to fabricate a light absorber layer in the CZTSe solar cells. The cell exhibited performance, with short-circuit current density of ~ 30.8 mA/cm2, open-circuit voltage of 0.39 V, ?ll factor of 0.47 and conversion ef?ciency of 5.8%.
关键词： Hot-injection method,Single phase,CZTSe nanoparticles,Copper-poor composition
更新于2025-09-23 15:19:57
-
Controllable synthesis of all inorganic lead halide perovskite nanocrystals and white light-emitting diodes based on CsPbBr3 nanocrystals
摘要： The colloidal cesium lead halide perovskite nanocrystals (NCs) have attracted much attention over the past five years as a promising class of material with potential application in wide-color-gamut backlight display because of their high photoluminescence quantum yield (PLQY) and narrow-band emission (full-width at half-maximum, FWHM < 35 nm). To controllably synthesize perovskite NCs, the effects of reaction temperature and reaction time on structure, morphology, particle size and photoluminescence (PL) properties of the NCs were systematically investigated in this article. Based on these results, the formation kinetics of the perovskite NCs was analyzed and disclosed in further. Finally, a white light-emitting diode (WLED) was prepared by using synthesized CsPbBr3 NCs and K2SiF6:Mn4+ phosphors as the color converters. The WLED exhibits the bright white emission with a CIE chromaticity coordinate of (0.389, 0.376) and a wide color gamut of 123% of NTSC, indicating a potential application in the field of wide color gamut displays in the future.
关键词： Cesium lead halide perovskite,white light-emitting diodes,photoluminescent,hot-injection method,nanocrystals
更新于2025-09-23 15:19:57
-
Cu2AgInSe4 QDs sensitized electrospun porous TiO2 nanofibers as an efficient photoanode for quantum dot sensitized solar cells
摘要： To obtain an efficient quantum dot sensitized solar cell (QDSC), a less toxic quaternary Cu2AgInSe4 QDs with 4.8 nm in size are synthesized by a simple hot injection method. The crystallite size and tetragonal structure are confirmed by XRD and HR-TEM analysis. Energy-dispersive X-ray spectroscopy analysis reveals that the atomic ratio of Cu: Ag: In: Se in the Cu2AgInSe4 QDs is 1.98:1.0:1.03:3.86. The oxidation state of the elements composed in Cu2AgInSe4 QDs is confirmed by XPS studies. Optical properties are studied from the UV–Vis–NIR absorption spectrum and photoluminescence emission spectrum. The porous TiO2 nanofibers (P-TiO2 NFs) are prepared from the conventional electrospun TiO2 NFs followed by the solvosonication process. The FE-SEM analysis is confirmed the porous texture of the TiO2 NFs. The bandgap of the Cu2AgInSe4 QDs and TiO2 NFs are determined from the Tauc plot and it was found to be 1.93 eV and 3.19 eV, respectively. QDSC is assembled using Cu2S counter electrode, polysulfide redox couple electrolyte and Cu2AgInSe4 QDs sensitized P-TiO2 NFs photoanode. The photoconversion efficiency (PCE) of the assembled QDSC is found to be 4.24%.
关键词： Tauc plot,QDSC,Porous TiO2 Nanofibers,Cu2AgInSe4 QDs,Hot injection method
更新于2025-09-23 15:19:57
-
Investigation of Microwave Irradiation Procedure for Synthesizing CdSe Quantum Dots
摘要： In recent years, microwave heating techniques for quantum dot (QD) synthesis have come to supplement the typical hot-injection methods. In addition to increasing control and replicability, microwave synthesis can be up-scaled to industry standards, an advantage that increases its lucrativeness. This study depicts a strategy to take a hot-injection procedure for cadmium selenide (CdSe) QD synthesis that is safe enough for undergraduate research labs and adapt it to an easier, more energy-efficient microwave synthesis method. Additionally, this study details successes in synthesizing these QDs, along with some challenges, limitations, and peculiarities. For future users of this method, it is recommended to keep holding temperatures between 170°C and 240°C to achieve the highest monodispersity of CdSe QDs while also avoiding confounding effects, such as wide-spectrum photoluminescence and bulk CdSe precipitation.
关键词： microwave synthesis,photoluminescence,hot-injection method,quantum dots,CdSe
更新于2025-09-23 15:19:57
-
Ligand engineering of colloid quantum dots and their application in all-inorganic tandem solar cells
摘要： How to effectively utilize the energy of the broad spectrum of sunlight is one of the basic problems in the research of tandem solar cells. Due to their size effect, quantum confinement effect and coupling effect, colloidal quantum dots (QDs) exhibit new physical properties that bulk materials don’t possess. CdX (X=Se, S, etc.) and PbX (X=Se, S, etc.) QDs prepared by hot-injection methods have been widely studied in the areas of photovolitaic devices. However, the surfactants surrounding QDs seriously hinder the charge transport of QDs based solar cells. Therefore, how to fabricate high-performance tandem solar cells via ligands engineering has become a major challenge. In this paper, the latest progress of colloidal QDs in the research of all-inorganic tandem solar cells was summarized. Firstly, the improvement of QDs surface ligands and the optimization of ligands engineering were discussed, and the control of the physical properties of QDs films were realized. From the aspects of colloidal QDs, ligand engineering, and solar cell preparation, the future development direction of colloidal QDs solar cells was proposed, providing technical guidances for the preparation of low-cost and high-efficiency nanocrystalline solar cells.
关键词： Tandem solar cell,Colloidal quantum dots,Hot-injection method,Ligand engineering
更新于2025-09-23 15:19:57