- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Investigating the Photovoltaic Performance of Surfactant assisted MoBi2Se5 Thin Films
摘要： MoBi2Se5 has been proved to be a promising material for the photoelectrochemical solar cell application. As, MoBi2Se5 thin films are more corrosion resistant than Bi2Se3 thin films also MoBi2Se5 can be used as a buffer layer due to its distinctive optostructural properties. In this study, we have synthesized surfactant assisted nanostructured MoBi2Se5 thin films by using cost effective chemical route, i.e. arrested precipitation technique (APT). The synthesized thin films were analyzed for their Opto-structural, surface morphological, compositional and photovoltaic application using X-ray diffraction Technique (XRD), UV-Vis Spectroscopy, Scanning electron microscopy (SEM), Energy dispersive X-ray spectroscopy (EDAX) and its photoelectrochemical solar cell performance was checked respectively. The nanocrystalline nature of MoBi2Se5 thin films was confirmed from the XRD pattern. An increment in the optical band gap energy was observed with surfactant mediation. The surface morphology of MoBi2Se5 was changed from spherical to spongy balls like nanofibrous surface morphology after surfactant assistant. Furthermore, both the as synthesized and surfactant assisted MoBi2Se5 thin films showed the photoelectrochemical solar cell applicability.
关键词： thin films,arrested precipitation technique,MoBi2Se5,surfactant,photoelectrochemical solar cell
更新于2025-09-23 15:21:01
-
Light-controlled imaging of biocatalytic reactions via scanning photoelectrochemical microscopy for multiplexed sensing
摘要： A light-controlled multiplexing platform has been developed on the basis of a quantum dot-sensitized inverse opal TiO2 electrode with integrated biocatalytic reactions. Spatially resolved illumination enables multiplexed sensing and imaging of enzymatic oxidation reactions at relatively negative applied potentials.
关键词： light-controlled imaging,biocatalytic reactions,scanning photoelectrochemical microscopy,multiplexed sensing
更新于2025-09-23 15:21:01
-
Angstrom Thick ZnO Passivation Layer to Improve the Photoelectrochemical Water Splitting Performance of a TiO2 Nanowire Photoanode: The Role of Deposition Temperature
摘要： In this paper, we demonstrate that angstrom thick single atomic layer deposited (ALD) ZnO passivation can significantly improve the photoelectrochemical (PEC) activity of hydrothermally grown TiO2 NWs. It is found that this ultrathin ZnO coating can passivate the TiO2 surface defect states without hampering the carrier’s transfer dynamics. Moreover, a substantial improvement can be acquired by changing the deposition temperature of the ZnO layer (80 °C, and 250 °C) and named as 80 °C TiO2-ZnO, and 250 °C TiO2-ZnO. It was found that the deposition of this single layer in lower temperatures can lead to higher PEC activity compared to that deposited in higher ones. As a result of our PEC characterizations, it is proved that photoconversion efficiency of bare TiO2 NWs can be improved by a factor of 1.5 upon coating it with a single ZnO layer at 80 °C. Moreover, considering the fact that this layer is a passivating coating rather than a continuous layer, it also keeps the PEC stability of the design while this feature cannot be obtained in a thick shell layer case. This paper proposes a bottom up approach to control the electron transfer dynamics in a heterojunction design and it can be applied to other metal oxide combinations.
关键词： deposition temperature,atomic layer deposition,photoelectrochemical water splitting,ZnO passivation,TiO2 nanowire
更新于2025-09-23 15:21:01
-
Tandem photoelectrochemical cells for solar water splitting
摘要： Photoelectrochemical (PEC) water splitting without an external bias is a potential solution to the growing energy crisis because this method can directly convert solar energy into chemical energy. A tandem cell is a frequently used configuration for unassisted overall water splitting because of the advantages that each component are tied together to form a highly efficient integration. A tandem PEC water splitting device is based on different photoelectrode absorbers, and there are two main models including photoanode/photocathode (PEC/PEC) and photoelectrode/photovoltaic (PEC/PV) tandem cells. In this review, we will focus on the concepts, configurations and recent progress of PEC/PEC and PEC/PV cells. Light absorption and energy band matching are the key points to enhance the solar-to-hydrogen (STH) efficiency. Promoting the performance of a standalone semiconductor material and finding new materials, coupled with an optimized configuration, are future steps for the practical application of tandem PEC cells.
关键词： Solar energy,photoelectrochemical cell,tandem cell
更新于2025-09-23 15:21:01
-
Controlled growth of InGaN quantum dots on photoelectrochemically etched InGaN quantum dot templates
摘要： Controlled growth of InGaN quantum dots (QDs) using photoelectrochemically (PEC) etched InGaN QD templates is demonstrated. The InGaN QDs are grown by a self-assembly (SA) method using metal-organic chemical vapor deposition on templates consisting of planar GaN and PEC etched InGaN QDs for comparison. The InGaN QD templates are formed using quantum-size-controlled PEC etching of planar InGaN layers on GaN, which produces controlled QD radiuses with a statistical mean (μ) of 17.3 nm and standard deviation (σ) of 6.2 nm, and densities of 1.2 × 1010 cm?2. The PEC etched QDs are capped with an AlGaN interlayer and GaN barrier layer to recover a planar surface morphology for subsequent SA growth of QDs. The PEC QD templates behave as seeds via localize strain near the PEC QDs which provide improved control of the SA QD growth. The SA grown QDs on PEC QD templates are smaller and have controlled radiuses with μ = 21.7 nm and σ = 11.7 nm compared to the SA QDs on planar GaN templates with radiuses of μ = 37.8 nm and σ = 17.8 nm. Additionally, the dot densities of the SA QDs on PEC QD templates are ~3 times higher and more closely match the underlying densities of the template (8.1 × 109 cm?2). Multiple quantum dots (MQDs) are also grown on both templates that consist of 4 periods of SA QDs and AlGaN/GaN interlayer/barrier layers. The MQDs grown on PEC QD templates better retain their planarized smooth surfaces after barrier layer growth, and exhibit ~3 times stronger PL intensity at room temperature compared to MQDs grown on planar GaN.
关键词： Metalorganic chemical vapor deposition,Nitrides,Quantum dots,Light emitting diodes,Atomic force microscopy,Photoelectrochemical etching
更新于2025-09-23 15:21:01
-
Ti, Zn co-doped hematite photoanode for solar driven photoelectrochemical water oxidation
摘要： Although there have been many reports of metal doping to ameliorate the drawbacks of hematite as the photoanode for water oxidation, most of them focused on monometallic doping, and only a few of them payed attention to bimetallic doping. What is worse, the synergetic mechanism between two metal dopants was not su?ciently studied, especially the density functional theory (DFT) calculation. In this work, the n-type hematite was synthesized by introducing Ti dopant into hematite through the hydrothermal method, and dipping-sintering treatment was employed to further introduce homogeneously dispersed Zn dopant into that, forming the Ti, Zn co-doped hematite. Under the optimal condition, Ti-doped hematite photoanode reached approximately 2-times enhancement of the photocurrent density compared with the pristine one at 1.23 V vs. RHE, while Ti, Zn co-doped hematite anode obtained another 25% elevation. UV –Vis spectroscopy, Mott –Schottky plots, EIS analysis, photo-oxidation of hole scavenger (H 2 O 2 ), and DFT calculation were employed to understand the role of Ti, Zn dopant. Based on the obtained results, the synergetic mechanism of two dopants was discussed, i.e., the improvement of PEC performance of Ti, Zn co-doped hematite photoanode was possibly attributed to greater carrier density and improved charge separation e?ciency at the surface of hematite. This work provides new strategy and understanding of the improvement of PEC performance of hematite by doping engineering.
关键词： Photoelectrochemical water oxidation,Zn co-doping,Ti,DFT calculation,Hematite
更新于2025-09-23 15:21:01
-
Hydrogen Terminated Germanene for a Robust Selfa??Powered Flexible Photoelectrochemical Photodetector
摘要： As a rising star in the family of graphene analogues, germanene shows great potential for electronic and optical device applications due to its unique structure and electronic properties. It is revealed that the hydrogen terminated germanene not only maintains a high carrier mobility similar to that of germanene, but also exhibits strong light–matter interaction with a direct band gap, exhibiting great potential for photoelectronics. In this work, few-layer germanane (GeH) nanosheets with controllable thickness are successfully synthesized by a solution-based exfoliation–centrifugation route. Instead of complicated microfabrication techniques, a robust photoelectrochemical (PEC)-type photodetector, which can be extended to flexible device, is developed by simply using the GeH nanosheet film as an active electrode. The device exhibits an outstanding photocurrent density of 2.9 μA cm?2 with zero bias potential, excellent responsivity at around 22 μA W?1 under illumination with intensity ranging from 60 to 140 mW cm?2, as well as short response time (with rise and decay times, tr = 0.24 s and td = 0.74 s). This efficient strategy for a constructing GeH-based PEC-type photodetector suggests a path to promising high-performance, self-powered, flexible photodetectors, and it also paves the way to a practical application of germanene.
关键词： photoelectrochemical photodetectors,2D materials,germanene,germanane
更新于2025-09-23 15:21:01
-
Improved visible-light photocurrent based on ZnO/ZnS core–shell nanorods via interfacial engineering
摘要： Vertically aligned quasi two-dimensional (2D) ZnO nanorods (NRs) on carbon fiber paper were prepared by a modified hydrothermal approach, an individual ZnO nanorod has a diameter of 100–200 nm and a length of ~1 μm. ZnO/ZnS core-hell hierarchal structures with an outer ZnS shell of ~25 nm were fabricated under an elaborate sulfidation treatment. Compared to ZnO NRs a depressed near band emission at 380 nm and a significant enhanced visible light emission around 500 nm were observed for the ZnO/ZnS core-hell NRs from photoluminescence spectra. XPS and ESR measurements were carried out to study the ions constituents and the defects of the prepared samples. The prepared samples were used as photoelectrodes in visible-light self-powered photoelectrochemical cell-type detector. And an enhanced photocurrent of 6.79 μA was obtained, which is ten times as high as that of the bare ZnO electrode. The results show that the existence of sulfur vacancies and the formation of ZnO/ZnS heterostructure were able to promote photocurrent performance, the former increases the carrier concentration and leads to an upshift of work function; the latter makes the band bend and the photogenerated e–p pairs can be separated efficiently. The results will be helpful to implement visible-light device based on heterostructure via interfacial engineering.
关键词： visible light,carbon paper,work function,photoelectrochemical cell-type detector,ZnO/ZnS core–shell
更新于2025-09-23 15:21:01
-
Photoelectrochemical performances of Fe2O3 nanotube films decorated with cadmium sulfide nanoparticles via photo deposition method
摘要： Hematite is an appropriate compound for photoelectrochemical water splitting. However, passive surface state, high recombination rate of the photo induced electron-hole pairs and poor and slow charge transfer kinetics restrict the performance of hematite. In this work, CdS/Fe2O3NTs samples have been successfully prepared by coating of CdS nanoparticles on the surface of the self-organized Fe2O3NTs via photo deposition technique in order to enhance charge separation and charge transfer kinetics. FESEM (Field Emission Scanning Electron Microscopy), XRD (X-ray diffraction), DRS (Diffraction Reflection Spectroscopy) and XPS (X-ray Photoelectron Spectroscopy) analyses have been used to characterize the CdS/Fe2O3NTs photoelectrodes obtained. CdS/Fe2O3NTs has an intense visible light absorption and displays a red-shift of the band edge in comparison with the bare Fe2O3NTs, according to DRS test. The photocurrent density of Fe2O3NTs increased approximately 5 times upon coating with CdS, as shown by photoelectrochemical measurements, indicating the significant role of the introduction of CdS in the enhancement of photo catalytic activity. CdS/Fe2O3NTs may be promising and effective photoanodes in PEC water splitting given their simple preparation and good performance.
关键词： Cadmium sulfide,Photo deposition,Fe2O3 nanotube,Photoelectrochemical water splitting
更新于2025-09-23 15:21:01
-
Combustion synthesis and photoelectrochemical characterization of gallium zinc oxynitrides
摘要： We report a rapid combustion synthesis method for producing band gap tunable gallium zinc oxynitrides, a material of interest for water splitting applications. By varying the ratio of zinc and gallium, we can tune the band gap from 2.22 to 2.8 eV. Furthermore, nitrogen can be incorporated up to nearly 50% via replacement of oxygen without the need for high temperatures or an additional ammonolysis step. X-ray photoelectron spectroscopy (XPS) and EDX analysis suggests a preferential segregation of Zn to the surface of the as-synthesized particles, though the surface Ga/Zn molar ratio in the as-synthesized particles is correlated with the Ga/Zn molar ratio of the precursor materials. Photoelectrochemical measurements show that the oxynitride powders are photoactive under both AM1.5 and visible-only (k . 435 nm) irradiation. Hydrogen and oxygen were both evolved in half-reaction experiments under simulated AM1.5 irradiation without externally applied bias, although addition of an OER catalyst did not enhance the rate of oxygen formation, suggesting that intra- and interparticle recombination are signi?cant.
关键词： water splitting,photoelectrochemical,gallium zinc oxynitrides,band gap tuning,combustion synthesis
更新于2025-09-23 15:21:01