- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Absorption Coefficient Dispersion in Flash Thermography of Semitransparent Solids
摘要： Pulse and flash thermography are experimental techniques which are widely used in the field of non-destructive testing for materials characterization and defect detection. We recently showed that it is possible to determine quantitatively the thickness of semitransparent polymeric solids by fitting of results of an analytical model to experimental flash thermography data, for both transmission and reflection configuration. However, depending on the chosen experimental configuration, different effective optical absorption coefficients had to be used in the model to properly fit the respective experimental data, although the material was always the same. Here, we show that this effect can be explained by the wavelength dependency of the absorption coefficient of the sample material if a polychromatic light source, such as a flash lamp, is used. We present an extension of the analytical model to describe the decay of the heating irradiance by two instead of only one effective absorption coefficient, greatly extending its applicability. We show that using this extended model, the experimental results from both measurement configurations and for different sample thicknesses can be fitted by a single set of parameters. Additionally, the deviations between experimental and modeled surface temperatures are reduced compared to a single optimized effective absorption coefficient.
关键词： Dispersion,Flash thermography,NDT,Absorptance,Infrared thermography,Semitransparency
更新于2025-09-23 15:22:29
-
Tailoring PEDOT:PSS polymer electrode for solution-processed inverted organic solar cells
摘要： The review of this paper was arranged by A. Zaslavsky. Conductivity and work function of the conductive polymer, poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT:PSS), has been investigated for a top electrode of the solution-processed organic solar cells (OPV). It has been found that both conductivity and work function could be changed by adjusting the mixing ratio of different commercial grade PEDOT:PSS such as PH 1000 and AI 4083. A 2:1 vol ratio of PH 1000 and AI 4083 mixture provided the conductivity of 443 S/cm (corresponding sheet resistance (Rsh) of 260 Ω/sq) and the work function of 5.09 eV. Therefore, this PEDOT:PSS mixture may work as both a hole transport layer (HTL) and anode electrode of the OPV. For verifying, all-solution-processed bulk heterojunction (BHJ) inverted OPVs were fabricated using developed PEDOT:PSS conductive polymers as both HTL and anode top electrode. Under the AM1.5G spectrum calibrated 100 mW/cm2 illumination, fabricated all-solution-processed OPV provides a best photo-conversion efficiency (PCE) of 2.04% accounted from an open circuit voltage (Voc) of 576 mV, a short circuit current (Jsc) of 6.91 mA/cm2, and a fill factor (FF) of 51.2%. In addition, the final OPV exhibits semitransparency due to no metal electrode on top and transparency of the conductive polymer.
关键词： Organic photovoltaics,Semitransparency,All-solution-process,Work function,Conductivity,PEDOT:PSS
更新于2025-09-23 15:21:01