- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Possibilities of Dry and Lubricated Friction Modification Enabled by Different Ultrashort Laser-Based Surface Structuring Methods
摘要： In this contribution we report on the possibilities of dry and lubricated friction modification introduced by different laser surface texturing methods. We compare the potential of Laser-Induced Periodic Surface Structures and Laser Beam Interference Ablation on 100Cr6 steel in a linear reciprocating ball-on-disc configuration using 100Cr6 steel and tungsten carbide balls with load forces between 50 mN and 1000 mN. For dry friction, we find a possibility to reduce the coefficient of friction and we observe a pronounced direction dependency for surfaces fabricated by Laser Beam Interference Ablation. Furthermore, Laser-Induced Periodic Surface Structures result in a load-dependent friction reduction for lubricated linear reciprocating movements. This work helps to identify the modification behaviour of laser generated micro structures with feature sizes of approximately 1 μm and reveals new possibilities for surface engineering
关键词： lubricated friction,smart surfaces,laser surface texturing,laser beam interference ablation,laser-induced periodic surface structures,dry friction
更新于2025-11-21 11:18:25
-
Effects of single- and multi-shape laser-textured surfaces on tribological properties under dry friction
摘要： Textural morphology is an important factor influencing dry friction, and few studies have been conducted regarding the effects of single- and multi-shape textures on dry tribological properties. In this work, six types of textures including single- and multi-shape textures were produced on 40Cr steel samples by using a nanosecond laser. Reciprocating sliding tests under dry friction were conducted using a pin-on-disc friction tester. The influences of textured surfaces with different textures on tribological properties were investigated. Results showed that tribological properties were affected by different textural morphologies. The dimple-textured surface had the highest friction coefficient, followed by the groove-textured surface. The sinusoidal-textured surface had the lowest friction coefficient. The friction coefficients of multi-shape textured surfaces were lower than those of non-textured surfaces but higher than those of sinusoidal-textured surfaces. The wear properties of the tested surfaces were consistent with the friction-coefficient results. The sinusoidal- and sinusoidal–groove-textured surfaces can be considered as the optimum choices for dry reciprocating friction.
关键词： textural morphology,dry friction,tribological properties,surface texturing,Nanosecond laser processing
更新于2025-09-12 10:27:22