- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Effect of solvents on the self-assembly of long chain alkylphosphonic acids on indium tin oxide surface - In situ studies on the adsorption kinetics and electron transfer process
摘要： The spontaneous self-assembly process of phosphonic acids (PAs) onto indium tin oxide (ITO) surface has been studied in this work. We have carried out in situ adsorption kinetics studies of phosphonic acids in ethanol as a solvent using electrochemical impedance spectroscopy (EIS). Further, the effect of different solvents like ethanol, water, toluene and hexane on the structural integrity of the alkylphosphonic acid (CH3 (CH2)n PO3H2, n = 15,17) thin films on ITO surface has been investigated by using [Fe(CN)6]3-/4- as a redox probe. From the study of formation kinetics, it is concluded that molecular self-assembly process follows two adsorption steps, a fast first step followed by a slower second step. The results of cyclic voltammetric (CV) and impedance measurements show that phosphonic acids form a highly impermeable surface film on ITO when polar solvents like ethanol and water are used.
关键词： self assembly,Adsorption Kinetics,microelectrode array,Contact Angle,Capacitance,ITO,Phosphonic acid
更新于2025-09-23 15:23:52
-
Amplitude Modulation-based Electrical Stimulation for Encoding Multipixel Spatiotemporal Visual Information in Retinal Neural Activities
摘要： Retinal implants have been developed as a promising way to restore partial vision for the blind. The observation and analysis of neural activities can offer valuable insights for successful prosthetic electrical stimulation. Retinal ganglion cell (RGC) activities have been investigated to provide knowledge on the requirements for electrical stimulation, such as threshold current and the effect of stimulation waveforms. To develop a detailed 'stimulation strategy' for faithful delivery of spatiotemporal visual information to the brain, it is essential to examine both the temporal and spatial characteristics of RGC responses, whereas previous studies were mainly focused on one or the other. In this study, we investigate whether the spatiotemporal visual information can be decoded from the RGC network activity evoked by patterned electrical stimulation. Along with a thorough characterization of spatial spreading of stimulation current and temporal information encoding, we demonstrated that multipixel spatiotemporal visual information can be accurately decoded from the population activities of RGCs stimulated by amplitude-modulated pulse trains. We also found that the details of stimulation, such as pulse amplitude range and pulse rate, were crucial for accurate decoding. Overall, the results suggest that useful visual function may be restored by amplitude modulation-based retinal stimulation.
关键词： Degenerated Retina,Electrical Stimulation,Retinal Ganglion Cells,Retinal Implant,Spike Train Decoding,Microelectrode Array
更新于2025-09-23 15:22:29
-
[IEEE 2019 IEEE 46th Photovoltaic Specialists Conference (PVSC) - Chicago, IL, USA (2019.6.16-2019.6.21)] 2019 IEEE 46th Photovoltaic Specialists Conference (PVSC) - Nanoprobe-Enabled Electron Beam Induced Current Measurements on III-V Nanowire-Based Solar Cells
摘要： The development of two new types of high-density, electroless plated microelectrode arrays for CMOS-based high-sensitivity direct bacteria and HeLa cell counting are presented. For emerging high-sensitivity direct pathogen counting, two technical challenges must be addressed. One is the formation of a bacteria-sized microelectrode, and the other is the development of a high-sensitivity and high-speed amperometry circuit. The requirement for microelectrode formation is that the gold microelectrodes are required to be as small as the target cell. By improving a self-aligned electroless plating technique, the dimensions of the microelectrodes on a CMOS sensor chip in this work were successfully reduced to 1.2 μm × 2.05 μm. This is 1/20th of the smallest size reported in the literature. Since a bacteria-sized microelectrode has a severe limitation on the current flow, the amperometry circuit has to have a high sensitivity and high speed with low noise. In this work, a current buffer was inserted to mitigate the potential fluctuation. Three test chips were fabricated using a 0.6-μm CMOS process: two with 1.2 μm × 2.05 μm 1024 × 1024 and 4 μm × 4 μm (16 × 16) sensor arrays and one with 6-μm × 6-μm (16 × 16) sensor arrays; and the microelectrodes were formed on them using electroless plating. The uniformity among the 1024 × 1024 electrodes arranged with a pitch of 3.6 μm × 4.45 μm was optically verified. For improving sensitivity, the trenches on each microelectrode were developed and verified optically and electrochemically for the first time. Higher sensitivity can be achieved by introducing a trench structure than by using a conventional microelectrode formed by contact photolithography. Cyclic voltammetry (CV) measurements obtained using the 1.2 μm × 2.05 μm 16 × 16 and 6-μm × 6-μm 16 × 16 sensor arrays with electroless-plated microelectrodes successfully demonstrated direct counting of the bacteria-sized microbeads and HeLa cells.
关键词： Bacteria counting,HeLa cells,electroless plating,point-of-care testing,CMOS,microelectrode array
更新于2025-09-23 15:19:57
-
[IEEE 2019 IEEE 4th Advanced Information Technology, Electronic and Automation Control Conference (IAEAC) - Chengdu, China (2019.12.20-2019.12.22)] 2019 IEEE 4th Advanced Information Technology, Electronic and Automation Control Conference (IAEAC) - Deterministic hierarchical joint remote state preparation using partially entangled quantum channel
摘要： The development of two new types of high-density, electroless plated microelectrode arrays for CMOS-based high-sensitivity direct bacteria and HeLa cell counting are presented. For emerging high-sensitivity direct pathogen counting, two technical challenges must be addressed. One is the formation of a bacteria-sized microelectrode, and the other is the development of a high-sensitivity and high-speed amperometry circuit. The requirement for microelectrode formation is that the gold microelectrodes are required to be as small as the target cell. By improving a self-aligned electroless plating technique, the dimensions of the microelectrodes on a CMOS sensor chip in this work were successfully reduced to 1.2 μm × 2.05 μm. This is 1/20th of the smallest size reported in the literature. Since a bacteria-sized microelectrode has a severe limitation on the current flow, the amperometry circuit has to have a high sensitivity and high speed with low noise. In this work, a current buffer was inserted to mitigate the potential fluctuation. Three test chips were fabricated using a 0.6-μm CMOS process: two with 1.2 μm × 2.05 μm 1024 × 1024 and 4 μm × 4 μm (16 × 4) sensor arrays and one with 6-μm × 6-μm (16 × 16) sensor arrays; and the microelectrodes were formed on them using electroless plating. The uniformity among the 1024 × 1024 electrodes arranged with a pitch of 3.6 μm × 4.45 μm was optically verified. For improving sensitivity, the trenches on each microelectrode were developed and verified optically and electrochemically for the first time. Higher sensitivity can be achieved by introducing a trench structure than by using a conventional microelectrode formed by contact photolithography. Cyclic voltammetry (CV) measurements obtained using the 1.2 μm × 2.05 μm 16 × 4 and 6-μm × 6-μm 16 × 16 sensor arrays with electroless-plated microelectrodes successfully demonstrated direct counting of the bacteria-sized microbeads and HeLa cells.
关键词： microelectrode array,point-of-care testing,HeLa cells,electroless plating,Bacteria counting,CMOS
更新于2025-09-23 15:19:57
-
[IEEE 2019 10th IEEE International Conference on Intelligent Data Acquisition and Advanced Computing Systems: Technology and Applications (IDAACS) - Metz, France (2019.9.18-2019.9.21)] 2019 10th IEEE International Conference on Intelligent Data Acquisition and Advanced Computing Systems: Technology and Applications (IDAACS) - Solar Cell Data Acquisition System
摘要： The development of two new types of high-density, electroless plated microelectrode arrays for CMOS-based high-sensitivity direct bacteria and HeLa cell counting are presented. For emerging high-sensitivity direct pathogen counting, two technical challenges must be addressed. One is the formation of a bacteria-sized microelectrode, and the other is the development of a high-sensitivity and high-speed amperometry circuit. The requirement for microelectrode formation is that the gold microelectrodes are required to be as small as the target cell. By improving a self-aligned electroless plating technique, the dimensions of the microelectrodes on a CMOS sensor chip in this work were successfully reduced to 1.2 μm × 2.05 μm. This is 1/20th of the smallest size reported in the literature. Since a bacteria-sized microelectrode has a severe limitation on the current flow, the amperometry circuit has to have a high sensitivity and high speed with low noise. In this work, a current buffer was inserted to mitigate the potential fluctuation. Three test chips were fabricated using a 0.6-μm CMOS process: two with 1.2 μm × 2.05 μm 1024 × 1024 and 4 μm × 4 μm (16 × 4) sensor arrays and one with 6-μm × 6-μm (16 × 16) sensor arrays; and the microelectrodes were formed on them using electroless plating. The uniformity among the 1024 × 1024 electrodes arranged with a pitch of 3.6 μm × 4.45 μm was optically verified. For improving sensitivity, the trenches on each microelectrode were developed and verified optically and electrochemically for the first time. Higher sensitivity can be achieved by introducing a trench structure than by using a conventional microelectrode formed by contact photolithography. Cyclic voltammetry (CV) measurements obtained using the 1.2 μm × 2.05 μm 16 × 4 and 6-μm × 6-μm 16 × 16 sensor array with electroless-plated microelectrodes successfully demonstrated direct counting of the bacteria-sized microbeads and HeLa cells.
关键词： microelectrode array,point-of-care testing,HeLa cells,electroless plating,Bacteria counting,CMOS
更新于2025-09-19 17:13:59
-
[IEEE 2019 Photonics North (PN) - Quebec City, QC, Canada (2019.5.21-2019.5.23)] 2019 Photonics North (PN) - Femtosecond Laser Opening of Hollow-Filament Arrays: the Fiber Bragg Grating Opto-fluidic Sensor
摘要： The development of two new types of high-density, electroless plated microelectrode arrays for CMOS-based high-sensitivity direct bacteria and HeLa cell counting are presented. For emerging high-sensitivity direct pathogen counting, two technical challenges must be addressed. One is the formation of a bacteria-sized microelectrode, and the other is the development of a high-sensitivity and high-speed amperometry circuit. The requirement for microelectrode formation is that the gold microelectrodes are required to be as small as the target cell. By improving a self-aligned electroless plating technique, the dimensions of the microelectrodes on a CMOS sensor chip in this work were successfully reduced to 1.2 μm × 2.05 μm. This is 1/20th of the smallest size reported in the literature. Since a bacteria-sized microelectrode has a severe limitation on the current flow, the amperometry circuit has to have a high sensitivity and high speed with low noise. In this work, a current buffer was inserted to mitigate the potential fluctuation. Three test chips were fabricated using a 0.6-μm CMOS process: two with 1.2 μm × 2.05 μm 1024 × 1024 and 4 μm × 4 μm (16 × 4) sensor arrays and one with 6-μm × 6-μm (16 × 16) sensor arrays; and the microelectrodes were formed on them using electroless plating. The uniformity among the 1024 × 1024 electrodes arranged with a pitch of 3.6 μm × 4.45 μm was optically verified. For improving sensitivity, the trenches on each microelectrode were developed and verified optically and electrochemically for the first time. Higher sensitivity can be achieved by introducing a trench structure than by using a conventional microelectrode formed by contact photolithography. Cyclic voltammetry (CV) measurements obtained using the 1.2 μm × 2.05 μm 16 × 4 and 6-μm × 6-μm 16 × 16 sensor array with electroless-plated microelectrodes successfully demonstrated direct counting of the bacteria-sized microbeads and HeLa cells.
关键词： microelectrode array,point-of-care testing,HeLa cells,electroless plating,Bacteria counting,CMOS
更新于2025-09-19 17:13:59