- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Skin friction measurements on structured surfaces using Clauser-chart method and Oil film interferometry
摘要： Measurements of skin friction have been performed on flat and hexagonal concave surfaces using the conventional Clauser-chart method and the Oil film interferometry. The values of shear stress coefficients measured by the conventional Clauser-chart method on a flat plate were found to be up to 13 % higher from the ones deduced by the Oil film interferometry. The velocity profiles required for the Clauser-chart were obtained by using hot wire anemometry. The analysis of the results suggested that the conventional Clauser-chart method cannot be used to predict shear stresses acting on the hexagonal concave surfaces due to the existence of strong pressure gradients. Oil film interferometry not only provides accurate and direct values of shear stress coefficients but also helps to visualize the flow above the surface.
关键词： Oil film interferometry,skin friction,Clauser-chart
更新于2025-09-23 15:23:52
-
Skin Friction Measurements Using Oil Film Interferometry in a 3-D Supersonic Flowfield
摘要： The application of oil film interferometry (OFI) for the measurement of global skin friction on the surface beneath a complex three-dimensional supersonic flow is explored in this study. The flowfield is produced by a fin-generated oblique shock interacting with a compressible turbulent boundary layer. Measurements were obtained by modifying a comprehensive acquisition and processing software, previously developed for two-dimensional, low-speed flows, to measure skin friction distributions underneath such flows. This approach required the local flow direction on the surface, and therefore traditional oil flow visualization was coupled with OFI measurements. A cross-correlation-based algorithm was incorporated to extract flow direction from sequences of oil flow visualization images. Photogrammetry was used with both surface oil flow and OFI to ensure proper spatial overlap for the two measurements. Results from this study demonstrate the capability of the approach in a complex, supersonic flow field that contains regions of both separation and reattachment concomitant with a wide range of skin friction values. The skin friction results show excellent homogeneity, standard deviation of 5.1% of the mean, in the undisturbed boundary layer upstream of the interaction and capture well-resolved high shear gradients in the interaction region. A comparison to legacy data from a similar interaction shows matching trends within the developed flow.
关键词： three-dimensional flow,shock boundary-layer interaction,supersonic flow,oil film interferometry,skin friction
更新于2025-09-23 15:22:29
-
Infrared Thermography and DIT of Quadcopter Rotor Blades Using Laser Heating
摘要： A measuring method to detect wall flow topologies by active infrared thermography was developed. Quadcopter rotor blades were studied in typical hover and forward flight conditions, while using a high-power infrared laser to heat the blade surface. By this, the distance between heat source and measuring object could be significantly increased compared to conventional heat sources. The resulting images show little blurring at high signal-to-noise ratios. In steady-state flow conditions, wall flow topologies could be detected reliably and show good agreement with performed oil-film interferometry measurements. Wind tunnel experiments at forward flight conditions were conducted and indicate unsteady shifts of the transition location.
关键词： laser heating,rotor blades,differential infrared thermography,boundary-layer transition,thermography,oil-film interferometry
更新于2025-09-11 14:15:04