- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Spectral photoluminescence properties of YAG: Ce, R (R: Gd3+, Pr3+, Gd3+ and Pr3+) transparent fluorescent thin film prepared by pulse laser deposition
摘要： In order to overcome the shortcomings of insufficient red light component and poor thermal stability of commercial white light emitting diode (WLED), YAG:Ce, R (R: Gd3t and Pr3t) fluorescent thin films were prepared by pulse laser deposition (PLD). The composition and microstructure, photoluminescence properties, and red-enhanced mechanism of co-doped YAG fluorescent thin films, as well as the electroluminescence behavior of the corresponding WLEDs were investigated. Results showed that the doping of Pr3t caused the emission spectrum energy of Ce3t to migrate, and an emission peak appeared at 606 nm in the red region. The doping of Gd3t caused the emission spectrum of Ce3t to shift to the red region, and the main peak position of the Ce3t emission spectrum is red-shifted from 523 nm to 548 nm. The YAG:Ce,Pr,Gd fluorescent film not only realized the improvement of red light components and red-shift, but also increased the energy transmission efficiency from 33.3% to 51.9%. Moreover, results of the color coordinate analysis also showed that the co-doping of Gd3t and Pr3t made the luminescence closer to the red region, reducing the color temperatures and hues changed to warm. Thus, tri-doped transparent fluorescent thin film were prospective for WLED application.
关键词： Photoluminescence properties,Transparent thin film,Pulse laser deposition,YAG:Ce,Tri-doped YAG
更新于2025-09-23 15:19:57
-
Tandem Si Micropillar Array Photocathodes with Conformal Copper Oxide and a Protection Layer by Pulsed Laser Deposition
摘要： This work demonstrates the influence of high-quality protection layers on Si-Cu2O micropillar arrays created by pulsed laser deposition (PLD), with the goal to overcome photodegradation and achieve long-term operation during photoelectrochemical (PEC) water splitting. Sequentially, we assessed planar and micropillar device designs with various design parameters and their influence on PEC hydrogen evolution reaction. On the planar device substrates, a Cu2O film thickness of 600 nm and a Cu2O/CuO heterojunction layer with a 5:1 thickness ratio between Cu2O to CuO were found to be optimal. The planar Si/Cu2O/CuO heterostructure showed a higher PV performance (Jsc = 20 mA/cm2) compared to the planar Si/Cu2O device, but micropillar devices did not show this improvement. Multifunctional overlayers of ZnO (25 nm) and TiO2 (100 nm) were employed by PLD on Si/Cu2O planar and micropillar arrays to provide a hole-selective passivation layer that acts against photocorrosion. A micropillar Si/ITO-Au/Cu2O/ZnO/TiO2/Pt stack was compared with a planar device. Under optimized conditions, the Si/Cu2O photocathode with Pt as a HER catalyst displayed a photocurrent of 7.5 mA cm?2 at 0 V vs RHE and an onset potential of 0.85 V vs RHE, with a stable operation for 75 h.
关键词： tandem photocathode,copper oxide,Si micropillar array,hydrogen evolution reaction,pulse laser deposition
更新于2025-09-19 17:13:59
-
Electrochemical behaviour and analytical applications of a manganese porphyrin a?? silica hybrid film prepared by pulsed laser deposition
摘要： Hybrid nanomaterials can have superior properties in comparison with individual components, sometimes greatly improving their optoelectronic activity. For this reason, modified carbon electrodes were obtained using a hybrid material composed of 5,10,15,20-tetra(4-tolyl)porphyrinato manganese (III) chloride (MnTTP) embedded in a silica matrix. The laser ablation deposition technique (PLD) has been used to immobilize the manganese porphyrin–silica hybrid on the surface of the carbon electrodes. The successful transfer of the manganese-porphyrin was evidenced by UV–Vis absorption spectroscopy. The PLD-deposited hybrid film was characterized using AFM and electrochemical methods (cyclic voltammetry and square wave voltammetry). The viability of this hybrid nanomaterial film as a redox mediator for the anodic oxidation and sensitive voltammetric determination of ascorbic acid in buffer solution (pH = 6.5) is described. The recorded anodic process is attributed to its oxidation to dehydroascorbic acid, with satisfactory catalytic current response and low non-Faradaic current.
关键词： Mn-porphyrin,Silica matrix,Hybrid nanomaterial,Pulse laser deposition,Electrocatalytic film,Ascorbic acid
更新于2025-09-19 17:13:59