- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Understanding strong knocking mechanism through high-strength optical rapid compression machines
摘要： Strong knocking combustion has become the greatest challenge for advanced internal combustion engines to pursue thermal efficiency limits at high power density conditions. Arising from enclosed space and extreme combustion situations, the fundamental mechanism for strong knocking combustion has still not been fully understood. In this study, synchronization measurement was performed through simultaneous pressure acquisition and high-speed direct photography, and knocking experiments were comparatively conducted under spark-ignition (SI) and compression-ignition (CI) conditions in a high-strength optical rapid compression machine (RCM) with flat piston design. Strong knocking phenomena were reproduced through varying initial thermodynamic conditions, and localized autoignition (AI) initiation and reaction wave evolutions were visualized, companied by synchronous pressure and temperature trajectories. The results show that compared with initial temperature, initial pressure and equivalence ratio exhibit greater influence on the variations of knocking severity. The weighting of different contributors can be further quantified by an effective energy density that shows positive but nonlinear correlations with knocking severity. However, the distinctions between CI and SI knocking characteristics at identical effective energy density also reflect the essential role of the interplay between primary flame propagation and end-gas AI progress. Visualized combustion images show that through improving end-gas thermodynamic state and reactivity sensitivity, the primary flame propagation can enhance localized AI initiation and secondary intensive AI evolutions, facilitating combustion mode transitions into developing detonation. The significant influence of primary flame propagation is diminished until ignition delay time becomes sufficiently short. Finally, with estimated thermal heterogeneities in flat-piston RCM configurations, the ignition modes of strong knocking cycles are quantified by a non-dimensional ignition regime diagram, and favorable scaling agreements with strong and mixed ignition regimes are observed.
关键词： Rapid compression machine,Effective energy density,Reaction wave propagation,Strong knocking combustion,Ignition regime
更新于2025-09-19 17:15:36
-
Quantitative measurements of formaldehyde in the low-temperature oxidation of iso-octane using mid-infrared absorption spectroscopy
摘要： Time-resolved quantitative measurements of formaldehyde (HCHO) in the low-temperature oxidation of iso-octane using a rapid compression machine have been performed with mid-infrared laser absorption spectroscopy. Due to the weak interference of the broadband absorption of iso-octane, a two-color detection scheme was applied to HCHO detection. The cross-sections of HCHO and iso-octane in two colors were measured using the rapid compression machine in the temperature range of 450–737 K and pressure range of 100–700 kPa. The time-resolved quantitative HCHO profiles in the low-temperature oxidation of iso-octane at 0.77 MPa, 645 K, and an equivalence ratio of 1.0 were successfully obtained. The calculated HCHO profiles using the latest chemical kinetic model of iso-octane show the same tendency as the experimental profiles.
关键词： formaldehyde,mid-infrared absorption spectroscopy,iso-octane,low-temperature oxidation,rapid compression machine
更新于2025-09-16 10:30:52
-
Cavity-enhanced absorption sensor for carbon monoxide in a rapid compression machine
摘要： A sensor based on cavity-enhanced absorption spectroscopy (CEAS) was implemented for the first time in a rapid compression machine (RCM) for carbon monoxide concentration measurements. The sensor consisted of a pulsed quantum cascade laser (QCL) coupled to a low-finesse cavity in the RCM using an off-axis alignment. The QCL was tuned near 4.89 μm to probe the P(23) ro-vibrational line of CO. The pulsed mode operation resulted in rapid frequency down-chirp (6.52 cm ?1 / μs) within the pulse as well as a high time resolution (10 μs). The combination of rapid frequency down-chirp and off-axis cavity alignment enabled a near complete suppression of the cavity coupling noise. A CEAS gain factor of 133 was demonstrated in experiments, resulting in a much lower noise-equivalent detection limit than a single-pass arrangement. The sensor thus presents many opportunities for measuring CO formation at low temperatures and for studying kinetics using dilute reactive environments; one such application is demonstrated in this work using dilute n-heptane/air mixtures in the RCM. The formation of CO during first-stage ignition of n-heptane was measured over 802–899 K at a nominal pressure of 10 bar. These conditions correspond to the NTC region of n-heptane and such results provide useful metrics to test and compare the predictions of low-temperature heat release by different kinetic models.
关键词： n-heptane,Low-temperature heat release,Cavity-enhanced absorption spectroscopy,Rapid compression machine,Carbon monoxide
更新于2025-09-04 15:30:14