- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Temperature field distribution in polymer particles during surface-selective laser sintering
摘要： The dynamics of polymer particle heating by laser irradiation during surface-selective laser sintering (SSLS) has been studied both experimentally and theoretically. Water aerosol wetting of the polymer particle surface was applied to increase the absorbance of thulium fiber laser radiation at 1.96 μm. Theoretical modeling of the laser-induced thermal processes was performed in thermolabile polylactic-co-glycolic acid powder coated with a thin water layer. Temperature gradients on the surface and inside the sintered particle volume were evaluated and analyzed. It was shown that for certain optimized SSLS parameters an effective sintering process can be achieved by delicate melting of the particle surface only, without noticeable changes in the chemical and phase compositions of the internal domains.
关键词： surface-selective laser sintering,thermal imaging,polymer particles,wetting,analysis of thermal processes
更新于2025-09-23 15:19:57
-
Recent Problems of Heat-Transfer Simulation in Technological Processes of Selective Laser Melting and Fusion
摘要： The thermal processes arising upon the implementation of the additive technologies of selective laser melting and the fusion of metals and alloys are analyzed. An adequate description of the heat transfer upon the implementation of additive technological processes associated with high-intensity local heating by a moving laser beam and the phase transitions generated by a semifinished powder product, crystallization, and the concomitant effects in the growing element is the key to gaining insight into the microstructure and the efficient properties of the obtained material and the prevention of residual deformation (shrinkage) of the item. Currently, the main causes of unpredictable production defects are deviations of the shape of the final item from the preset geometry and high-amplitude residual stresses, which can initiate destruction of the item under loads significantly lower than those calculated, as well as the occurrence of the microscopic defects (pores, layer interfaces, etc.) are. The development of mathematical models that, on the one hand, are sufficiently accurate to predict the listed phenomena and, on the other hand, allow practical implementation in engineering calculations is the basis for the further development of the laser-melting and fusion of metal materials. At the same time, analysis of the current state of the problem shows that development of efficient numerical methods providing acceptable computational costs while maintaining accuracy is the key element in the practical implementation of the models. A method based on multiscale, interconnected modeling of the mechanical and the thermal state of the growing body—at the local level in the melt pool domain, at the intermediate level in the vicinity of the melt pool and the adjacent layers, and at the level of the entire product as a whole—seems to be efficient; here, the computing process at the global level can be based on a combination of the finite-element method (indisputable in practice) and analytical calculations providing local refinement of the solution.
关键词： numerical methods,heat-transfer simulation,microstructure,residual deformation,mathematical models,fusion,thermal processes,selective laser melting,additive technologies
更新于2025-09-23 15:19:57
-
Solar Engineering of Thermal Processes, Photovoltaics and Wind || Solar Process Loads
摘要： The supply of solar energy from a collector is time dependent. In general, loads to be met by an energy system are also time dependent. Energy storage, as outlined in the previous chapter, provides a buffer between these two time-dependent functions. In Chapters 6 and 7 we discussed calculation of collector output. In this chapter, we outline briefly the common methods for calculating some common loads and provide references which will provide much more detailed information.
关键词： energy storage,wind,solar energy,thermal processes,photovoltaics
更新于2025-09-16 10:30:52