- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
A field study on the application of distributed temperature sensing technology in thermal response tests for borehole heat exchangers
摘要： Although the enhanced thermal response test (ETRT) method has been used to determine the distribution of ground temperatures and effective thermal conductivities, there are a number of obstacles which limit the wide application of this technology in the discipline of geoengineering. In this literature, four aspects of ETRT technology were investigated: (a) acquisition of ground temperature, (b) installation of the heat exchange tubes, (c) optimization of the monitoring positions, and (d) the difference in thermal conductivity obtained by the ETRT and numerical simulation. To investigate these issues, a field trial was carried out in Heze, Shandong Province, China, and the corresponding numerical models were built. The results demonstrate that: (i) the conventional methods that infer undisturbed ground temperature using water in tubes have large errors, whereas the distributed temperature sensing (DTS) technique enables the measurement of precise temperature profiles; (ii) the thermal conductivity measured using double U-tubes reflects the soil thermal property more accurately than that for a single U-tube; (iii) it is more reasonable to install optical fibers outside the U-tube sidewall than inside the observation tube; and (iv) it is essential to quantitatively consider various interface thermal impedance when estimating ground thermal conductivities using numerical simulation.
关键词： Fiber optic sensor,Distributed temperature sensing (DTS),Ground-coupled heat pump (GCHP),Thermal conductivity,Thermal response test (TRT)
更新于2025-09-23 15:21:01
-
Distributed Thermal Response Tests Using a Heating Cable and Fiber Optic Temperature Sensing
摘要： Thermal response tests are used to assess the subsurface thermal conductivity to design ground-coupled heat pump systems. Conventional tests are cumbersome and require a source of high power to heat water circulating in a pilot ground heat exchanger. An alternative test method using heating cable was verified in the field as an option to conduct this heat injection experiment with a low power source and a compact equipment. Two thermal response tests using heating cable sections and a continuous heating cable were performed in two experimental heat exchangers on different sites in Canada and France. The temperature evolution during the tests was monitored using submersible sensors and fiber optic distributed temperature sensing. Free convection that can occur in the pipe of the heat exchanger was evaluated using the Rayleigh number stability criterion. The finite and infinite line source equations were used to reproduce temperature variations along the heating cable sections and continuous heating cable, respectively. The thermal conductivity profile of each site was inferred and the uncertainly of the test was evaluated. A mean thermal conductivity 15% higher than that revealed with the conventional test was estimated with heating cable sections. The thermal conductivity evaluated using the continuous heating cable corresponds to the value estimated during the conventional test. The average uncertainly associated with the heating cable section test was 15.18%, while an uncertainty of 2.14% was estimated for the test with the continuous heating cable. According to the Rayleigh number stability criterion, significant free convection can occur during the heat injection period when heating cable sections are used. The continuous heating cable with a low power source is a promising method to perform thermal response tests and further tests could be carried out in deep boreholes to verify its applicability.
关键词： fiber optic,geothermal,heating cable,thermal response test,thermal conductivity
更新于2025-09-19 17:15:36