- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Under-Etched Plasmonic Disks on Indium Tin Oxide for Enhanced Refractive Index Sensing on a Combined Electrochemical and Optical Platform
摘要： A simple approach to enhance the refractive index sensitivity of gold nanodisks immobilized on electrically conducting indium tin oxide (ITO) substrates has been demonstrated. A two-fold increase in sensitivity to bulk refractive index change was achieved by substrate under-etching of gold nanodisks on ITO in 50 mM sulfuric acid. The influence of an intermediate titanium adhesion layer was investigated and was found to markedly influence the etching pattern and time. Etching with an adhesion layer resulted in enhanced refractive index sensitivity on disk-on-pin like structures after long etching times, whereas etching of disks deposited directly on ITO resulted in a disk-on-pincushion like configuration and similarly enhanced sensitivity already at shorter times. The gold disks remained electrically connected to the ITO substrate throughout etching and allowed site-specific electrodeposition of poly(3-aminophenol) at the nanodisks, showing enhanced thin-film refractive index sensitivity. This work demonstrates a simple method for enhancing refractive index sensitivity of nanostructures on ITO substrates for combined electrochemical and optical platforms, and subsequently a method to modify the surface of the electrically connected nanostructures, which has potential application in biosensing.
关键词： plasmonics,refractive index sensor,colloidal lithography
更新于2025-09-23 15:19:57
-
Nanostructures of functionalized zinc phthalocyanines prepared with colloidal lithography: Evaluation of surface orientation and dimensions using scanning probe microscopy
摘要： Patterned arrays of nanoholes and nanorings were prepared using colloidal lithography combined with steps of solution immersion and vapor deposition of organosilanes. Samples prepared with colloidal lithography exhibit millions of reproducible test structures with a periodic arrangement throughout areas of the surface according to the dimensions and spacing of the particle mask. Views of the size and morphology of nanopatterns obtained with atomic force microscopy (AFM) can provide information of progressive steps of chemical reactions as nanostructures are grown within spatially confined areas surrounded by a resist film. A surface mask of colloidal latex or silica spheres was used to protect discrete areas of a Si(111) substrate from the deposition of organosilanes. When the mask was removed, the uncovered areas of the surface revealed regularly-shaped, small sites of uncovered substrate available for further reaction steps to build hierarchical surface structures. Nanostructures of zinc phthalocyanines (ZnPcs) were constructed using amine-terminated nanopatterns as sites for binding. Spatial selectivity was achieved for directing the attachment of ZnPcs to the surface using resist films of 2-[methoxy(polyethyleneoxy)propyl]trichlorosilane (PEO-silane) and also with octadecyltrimethoxysilane (OTMS). The molecule chosen as a linker was (3-aminopropyl)triethoxysilane (APTES) which presents an amine group at the interface. In general, phthalocyanine molecules tend to bind in a coplanar orientation by physisorption to the surface and can stack together through pi-pi interactions between adjacent macrocycles. However, the nature of the substituents will also influence whether the molecules assemble on surfaces in a side-on orientation or with the macrocycle oriented in a coplanar arrangement. Hydroxyl and isothiocyanate pendant groups were attached to the macrocycles of ZnPcs chosen for this study, to investigate conformational differences when attached to APTES nanopatterns. The size and morphology of nanostructures was visualized and sensitively measured with tapping-mode AFM. The elastic response of samples patterned with ZnPc was mapped with force modulation AFM. Changes in the height of nanostructures indicate whether the macrocycles are oriented upright or parallel to the surface plane, or if multilayers were formed.
关键词： Atomic force microscopy,Colloidal lithography,Nanopatterning,Phthalocyanines
更新于2025-09-23 15:19:57
-
Interaction-tailored organization of large-area colloidal assemblies
摘要： Colloidal lithography is an innovative fabrication technique employing spherical, nanoscale crystals as a lithographic mask for the low cost realization of nanoscale patterning. The features of the resulting nanostructures are related to the particle size, deposition conditions and interactions involved. In this work, we studied the absorption of polystyrene spheres onto a substrate and discuss the effect of particle–substrate and particle–particle interactions on their organization. Depending on the nature and the strength of the interactions acting in the colloidal film formation, two different strategies were developed in order to control the number of particles on the surface and the interparticle distance, namely changing the salt concentration and absorption time in the particle solution. These approaches enabled the realization of large area (≈cm2) patterning of nanoscale holes (nanoholes) and nanoscale disks (nanodisks) of different sizes and materials.
关键词： localized surface plasmon resonance,large-area nanostructure patterning,colloidal lithography,spherical nanoparticles,electrostatic interactions
更新于2025-09-19 17:15:36
-
Optical nanogap antennas as plasmonic biosensors for the detection of miRNA biomarkers
摘要： Nanoplasmonic biosensors based on nanogap antennas structures usually demand complex and expensive fabrication processes in order to achieve a good performance and sensitive detection. We here report the fabrication of large-area nanoplasmonic sensor chips based on nanogap antennas by employing a customized, simple and low-cost colloidal lithography process. By precisely controlling the angle for tilted e-beam metal evaporation, an elliptical mask is produced, which defines the total length of the dipole antenna nanostructures while assuring that the plasmonic response is oriented in the same direction along the sensor chip. Large-area sensor chips of nanogap antennas formed by pairs of gold nanodisks separated by gaps with an average size of 11.6 ± 4.7 nm are obtained. The optical characterization of the nanogap antenna structures in an attenuated total reflection (ATR) configuration shows a bulk refractive index sensitivity of 422 nm/RIU, which is in agreement with FDTD numerical simulations. The biosensing potential of the cm2-sized nanostructured plasmonic sensor chips has been evaluated for the detection of miRNA-210, a relevant biomarker for lung cancer diagnosis, through a DNA/miRNA hybridization assay. A limit of detection (LOD) of 0.78?nM (5.1 ng mL-1) was achieved with no need of further amplification steps, demonstrating the high sensitivity of these plasmonic nanogap antennas for the direct and label-free detection of low molecular weight biomolecules as miRNAs.
关键词： nanoplasmonic biosensors,miRNA biomarkers,colloidal lithography,nanogap antennas,lung cancer diagnosis
更新于2025-09-19 17:13:59
-
Interfacial Capillarya??Forcea??Driven Selfa??Assembly of Monolayer Colloidal Crystals for Supersensitive Plasmonic Sensors
摘要： Colloidal lithography technology based on monolayer colloidal crystals (MCCs) is considered as an outstanding candidate for fabricating large-area patterned functional nanostructures and devices. Although many efforts have been devoted to achieve various novel applicatons, the quality of MCCs, a key factor for the controllability and reproducibility of the patterned nanostructures, is often overlooked. In this work, an interfacial capillary-force-driven self-assembly strategy (ICFDS) is designed to realize a high-quality and highly-ordered hexagonal monolayer MCCs array by resorting the capillary effect of the interfacial water film at substrate surface as well as controlling the zeta potential of the polystyrene particles. Compared with the conventional self-assembly method, this approach can realize the reself-assembly process on the substrate surface with few colloidal aggregates, vacancy, and crystal boundary defects. Furthermore, various typical large-scale nanostructure arrays are achieved by combining reactive ion etching, metal-assisted chemical etching, and so forth. Specifically, benefiting from the as-fabricated high-quality 2D hexagonal colloidal crystals, the surface plasmon resonance (SPR) sensors achieve an excellent refractive index sensitivity value of 3497 nm RIU?1, which is competent for detecting bovine serum albumin with an ultralow concentration of 10?8 m. This work opens a window to prepare high-quality MCCs for more potential applications.
关键词： colloidal lithography,plasmonic sensors,monoloidal colloidal self-assembly,nanostructure arrays,interfacial capillary force
更新于2025-09-16 10:30:52
-
Particulate Coatings with Optimized Haze Properties
摘要： The haze factor, which describes the fraction of light that is scattered when passing through a transparent material, is of general importance for any optical device, from milk glass shielding visibility while providing ambient lighting to solar cells that are optimized by sophisticated light management layers. Often, such active layers are fabricated from particulate materials that are deposited as thin films on a substrate. Here, the effect of structural arrangement, position, and orientation of particles on the resulting haze factor is investigated. A mathematical optimization model that iteratively alters the particle layer structure to maximize or minimize the haze factor for a range of optimization scenarios is designed. Colloidal self-assembly techniques are then used to replicate typical particle structures found in the optimized designs and correlate the macroscopically measured haze values to the predictions of the optimization. The results indicate general design rules that control the haze value in particle layers. Non close-packed structures with distributed scatterers and high degrees of order provide minimal haze values while chain-like arrangements and small clusters maximize the haze of a particle layer. Finally, the findings are transferred to metal nanohole films as model transparent electrodes with controlled haze values.
关键词： haze factor,electromagnetic scattering,thin films,colloidal lithography,colloids,mathematical optimization
更新于2025-09-10 09:29:36