摘要： In the present work, successful manganese oxide (Mn2O3) nanoparticles (NPs) were synthesized by a combustion technique, while the casting process was employed for the manufacturing of polymer nanocomposites with various weights of Mn2O3 based on Poly(Vinyl Alcohol), PVA. Multiple methods such as X-ray diffraction (XRD), HR-TEM, EDAX, EDS, SEM, FT-IR, DTA analysis, optical spectroscopy from UV to IR regions, and optical reduction (CUT-OFF) setup were used to characterize the structural, elemental chemical analysis, morphological, optical properties, and cut-off laser characteristic of nanocomposite samples. Mn2O3 nanoparticles have a crystallite size of 22.08 nm as calculated using the Debye–Scherer formula from XRD, while the HR-TEM shows a spherical particle of size 30–38 nm range. EDAX spectra and EDS mapping were used to detect the elemental particles of the nanocomposite. The external morphology of the films by SEM images shows an increase in the agglomeration size of the cluster with the percentage of Mn2O3 nanoparticles in PVA. FT-IR spectra show excellent incorporation between the matrix of polymer and the Mn2O3 via the hydroxyl group. Moreover, with increasing the doping rate of nanoparticles, the thermal stability of PVA increased. A significant change of optical transmittance, absorption edge, Urbach energy, and transition bandgap have been observed due to the influence of Mn2O3. The comparison between the bandgap values that have been estimated from Tauc’s relation and thus resulting from optical dielectric loss indicates a direct allowed transition of electrons in the nanocomposites. The light is entirely UV–Vis absorbed by PVA with a high percentage of Mn2O3 nanoparticles. Moreover, the efficiency of the films to decrease the power of two laser beams (635 nm and 533 nm) has been observed. The flexible films of PVA with an elevated rate of Mn2O3 are considered a successful option for low-cost technologies of optical limiting.